User Guide
Table Of Contents
- Contents
- Preface
- 1.1.1 Make a 3D Model
- 1.1.2 Slice and Export the 3D Model
- Chapter 2: About Creator Pro
- 2.1 About Your Creator Pro
- 2.1.1 Views
- Chapter 3: Unpacking
- Chapter 4: Hardware Assembly
- Chapter 5: Build Plate Leveling
- Chapter 6: About Software
- This chapter talks about the basic function of Fla
- 6.1 Software Installation
- 6.2 Exploring FlashPrint
- ①Changing views
- ②Set View
- ③Reset View
- ④Show Model Outline
- ⑤Show Steep Overhang
- 6.2.5 Move
- 6.2.6 Rotate
- 6.2.7 Scale
- 6.2.8 Cut
- 6.2.9 Extruder
- 6.2.10 Supports
- ②Auto Supports
- ③Add Supports
- ④ Clear Supports
- Click [Clear Supports], all supports will be delet
- ⑤Delete Supports
- 6.2.11 Print
- ①New Project
- ②Saving
- ③ Preferences
- 6.2.13 Edit Menus
- 6.2.14 Tools
- 6.2.15 Help Menus
- 7.1 Generate a Gcode
- 7.1.1 Installing Filament
- 7.2 Loading the Filament Using the LCD Panel
- 7.3 Unloading the Filament Using LCD Panel
Creator Pro User Guide | www.FlashForge.com 400-699-1063
30
6.2.7 Scale
Select the target object and scale the object by the following two methods:
Method 1: Click the [Scale] icon on the left, hold down the left mouse button and
scale the model. The corresponding values will display near the object..
Method 2: Click the [Scale] icon on the left and then enter into scale values in X/Y/Z
axes positioning. Click the [Maximum] button to get largest size possible for building.
Click [Reset] to reset the size of model.
Note: If the [Uniform Scaling] radio button is clicked, it will scale the model in equal
proportion when changing value in any positioning of the model. Otherwise it will
only change the value of the corresponding positioning.
6.2.8 Cut
Click on the model to select it and click on the Cut icon to set the cut plane. The
direction and position are available for setting.
①Draw with Mouse
②X Plane