User Guide
Table Of Contents
- Contents
- Preface
- 1.1.1 Make a 3D Model
- 1.1.2 Slice and Export the 3D Model
- Chapter 2: About Creator Pro
- 2.1 About Your Creator Pro
- 2.1.1 Views
- Chapter 3: Unpacking
- Chapter 4: Hardware Assembly
- Chapter 5: Build Plate Leveling
- Chapter 6: About Software
- This chapter talks about the basic function of Fla
- 6.1 Software Installation
- 6.2 Exploring FlashPrint
- ①Changing views
- ②Set View
- ③Reset View
- ④Show Model Outline
- ⑤Show Steep Overhang
- 6.2.5 Move
- 6.2.6 Rotate
- 6.2.7 Scale
- 6.2.8 Cut
- 6.2.9 Extruder
- 6.2.10 Supports
- ②Auto Supports
- ③Add Supports
- ④ Clear Supports
- Click [Clear Supports], all supports will be delet
- ⑤Delete Supports
- 6.2.11 Print
- ①New Project
- ②Saving
- ③ Preferences
- 6.2.13 Edit Menus
- 6.2.14 Tools
- 6.2.15 Help Menus
- 7.1 Generate a Gcode
- 7.1.1 Installing Filament
- 7.2 Loading the Filament Using the LCD Panel
- 7.3 Unloading the Filament Using LCD Panel
Creator Pro User Guide | www.FlashForge.com 400-699-1063
45
7-9
7.2 Loading the Filament Using the LCD Panel
1. Turn on the Creator Pro; the display will indicate:
▶ Print from SD
Preheat
Utilities
2. Using the directional arrow buttons in the right of the screen, to select Utilities and
then press the OK. The display will show:
Monitor Mode
▶ Filament loading
Preheat Setting
General Settings
3. Select Filament loading; press the OK key of the keypad. The display will show:
▶ Load Right
Unload Right
Load Left
Unload Left
4. Select the appropriate side of the extruder you wish to load (Left or Right for
models with dual extruders). Press the OK key again on the keypad. The display will
indicate: I'm heating up my extruder!” At this time, the temperature of the right nozzle
is being heated up. When the temperature of the nozzle reaches its target temperature,