User Guide

Creator Pro User Guide | www.FlashForge.com 400-699-1063
46
pressing the OK key on the keypad, and the nozzle should start extruding filament. If
not, keep pressing the OK key until it does.
7.3 Unloading the Filament Using LCD Panel
1) Turn on the Creator Pro, the display will indicate:
Build from SD
▶ Preheat
Utilities
2) Using the directional arrow buttons in the right of the screen to select Preheat,
Press OK key on the keypad, then you will see
：
▶ Start Preheating
Right Extruder OFF
Left Extruder OFF
Platform OFF
3) Press page down key to select Left Extruder (or Right Extruder), press OK
key, you will see
：
▶Start Preheating
Right Extruder ON
Left Extruder ON
Platform OFF
4) Press page up key back to Start Preheat, and Press OK key, you will see:
CAUTION
If you just finished your printing or already extruded the filament and want to withdraw
the filament, at this moment, the extruder is still over 200°C, first push the filament in a little
further, and then directly pull it out.
If you want to change another color filament, first you need to withdraw filament and then
load in. Please do as following shown to avoid filament jam.