User Guide
Table Of Contents
- Contents
- Preface
- 1.1.1 Make a 3D Model
- 1.1.2 Slice and Export the 3D Model
- Chapter 2: About Creator Pro
- 2.1 About Your Creator Pro
- 2.1.1 Views
- Chapter 3: Unpacking
- Chapter 4: Hardware Assembly
- Chapter 5: Build Plate Leveling
- Chapter 6: About Software
- This chapter talks about the basic function of Fla
- 6.1 Software Installation
- 6.2 Exploring FlashPrint
- ①Changing views
- ②Set View
- ③Reset View
- ④Show Model Outline
- ⑤Show Steep Overhang
- 6.2.5 Move
- 6.2.6 Rotate
- 6.2.7 Scale
- 6.2.8 Cut
- 6.2.9 Extruder
- 6.2.10 Supports
- ②Auto Supports
- ③Add Supports
- ④ Clear Supports
- Click [Clear Supports], all supports will be delet
- ⑤Delete Supports
- 6.2.11 Print
- ①New Project
- ②Saving
- ③ Preferences
- 6.2.13 Edit Menus
- 6.2.14 Tools
- 6.2.15 Help Menus
- 7.1 Generate a Gcode
- 7.1.1 Installing Filament
- 7.2 Loading the Filament Using the LCD Panel
- 7.3 Unloading the Filament Using LCD Panel
Creator Pro User Guide | www.FlashForge.com 400-699-1063
50
Display Config
select it and then press OK ; the display will indicate
Config
X Offset
Y Offset
Z Offset
Right Temp
Left Temp
Platform Temp
Change Name
Save To Profile
●Home offsets
select it and then press OK ; the display will indicate:
X Offset
Up/Dn/Left/OK to Set (Press Up button and Down button to
change the X/Y axis coordinate; press OK to confirm; press Left
button to back)
●Toolhead Offsets
●Jog Mode
select it and then press OK ; the display will indicate:
X+
Y-
X-
Press Right/Left button change the X/Y/Z axis interface; press
Up/Dn button to change the coordinate; press OK button to back.
●Enable steppers
select it and then press OK ; the display will indicate: