User's Guide

E3 Pro User Guide | www.flashforge.com 0086-0579-82273989
25
Chapter 4: Hardware Assembly
Your E3 Pro has been installed before leaving factory, you can start up the E3 Pro for
printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
4-1
(4-1) The filament cartridge is at the rear of E3 Pro. Lift the cartridge out of the E3
Pro.
4-2
(4-2) Take out the filament and thread it through the filament detecting equipment.
Filament Detecting
Equipment in the black.