User's Guide

E3 Pro User Guide | www.flashforge.com 0086-0579-82273989
26
(Note: The filament should feeds from the bottom of the spool towards the top )
4.2 Printer Start-up
4-3
(4-3)Insert the power supply into the power input on the back of the E3 Pro and plug
the power cord into an electrical outlet. （图 4-3）电源线接口位于设备背面。请将
电源线一端连接机器上的插口，另一端连接插座。并将主板电源开关打开，即“I”
往右按。
4.3 Loading Filament
For stable filament loading and proper device protection, you need to install the
filament guide tube properly.
(4-4) Take out the filament guide tube, thread the filament from Filament
Detecting Equipment
4-4