Instructions

[Einstellungen] -[Platform heat Preservation]
The insulation duration of the platform can be set from 1 to 10 minutes. When the printing finished, the platform will keep heating
the current setting time. Reduce the heating time for printing the second model.
[Einstellungen] -[Test Extruder Sensor]
The detection function of extruder sensor is able to detect whether the sensor is abnormal; If it cannot be triggered, please adjust
the sensitivity of the sensor and try again. If it still cannot be triggered, the sensor is damaged, should be changed.
[Einstellungen] -[Steel Brush/Anti oozing plate]
support two type plate.
Steel brush ：Extruder moving at Y direction;
Anti oozing plate：A section of filament will be soit out in advance to avoid the oozinng. The anti-oozing plate is a new aption,
suggest to use it.
44