Owner manual

ManualsBrandsFleet Engineers ManualsHardwareINS-03030

Spray Master

and

Spray Mate

With Slidetrax

Fender Installation Instructions

Installation Sheet #INS-03030

Patent 7384071

2. Assemble the Slidetrax

clamps

by inserting the threaded T-nuts

into the clamps from the inside

and pushing them into place.

1. Position fender over tires. Use a 2”x4” block or other suitable

spacer to achieve desired clearance around tires. S.A.E.

recommendation is 3” minimum (below the ribs).

Note: If you have an air suspension make sure there is tire

clearance when the suspension is deﬂated.

NOTE: These instructions for installing Spray Master

and Spray Mate

with Slidetrax

fenders are intended to

be a general guide to help the installer. Because of the

large number of possible mounting

conﬁgurations, the installer is

responsible for the installation

design and for providing

adequate clearance

around the tire

carrier (i.e. tire

clearance, trailer

clearance, etc.)

These products may

not ﬁt all truck models or

types of suspensions. Check

truck or trailer manufacturer for

suspension travel speciﬁcations.

Modiﬁcations to the brackets and/or the

fenders may be required. Any modiﬁcations

are at the discretion, responsibility and risk of

the installer.

3. Insert a mounting tube through a Slidetrax

clamp to use as a

guide. On the frame

side of the fender, position

the clamp (with tube) on

the Slidetrax

. Move the

clamp on the Slidetrax

as necessary to select an

existing hole or mark a

space on the frame to drill

a new hole.

Note: Be sure to follow truck

or trailer manufactureres

recommended procedures for

drilling any required holes in the

frame.

4. Once the position of the

mounting tube is chosen,

slide the other Slidetrax

clamp onto the tube, making

sure that they are square to

the truck frame, then mark

the positions of the clamps

on the fender.

5. Repeat step 3 and 4 for the

other mount.

6. Remove the fender from over the

tire and place the Slidetrax

clamps on the fender at the

marked positions. Engage

the Slidetrax

teeth and

ﬁrmly push clamps onto the

fender until they snap into

place. Once in place, rap

with a soft hammer to seat the

clamp into the Slidetrax

Note: If clamp removal or reposition is necessary, an

outward rap with a soft hammer will disengage it.

Mark Spot

Slide onto mounting tube

Slidetrax

7. Mount the mounting tubes to the truck frame according to the

instructions provided with the mounts.

Note: It may be easier to leave the bolts loose enough to allow

some movement until the ﬁnal positioning of the fender.

9. Position the fender over the tires and secure in place by

tightening all bolts to the proper torque and installing the set

screws in the Slidetrax

clamps and tightening to maximum

torque of 48 in. lbs. +/

3in. lbs. or 4 ft. lbs.

Spacer

Blocks

Spray

Master

Spacer

Blocks

Truck

Frame

3" Minimum

Below Ribs

3" Minimum

Below Ribs

Installation Sheet # INS-03030 • Rev. E 2/13

8. Slide the fender with attached Slidetrax

clamps on to the

mounting tubes already attached to the frame.

Please Note:

Flap weights are not recommended and may void

the warranty.

Painting Spray Master

and

Spray Mate

with

SlideTrax

fenders IS NOT recommended and may

void the warranty. If painting is desired, a Flex Agent

MUST be added to the paint!