User's Manual

2.1.1.4.2. Mic w/Lesson (Microphone with Lesson)

This function is used by the instructor to talk to all students listening to the same lesson channel as

selected with the “LESSON SELECT” buttons. For example, to talk to students listening to lesson

channel #1, press the “LESSON 1” button and the “MIC W/ LESSON” button. Be sure to cancel

“MIC W/ LESSON” by pressing the button again when you no longer wish to speak with the

students. Students will notice that during this mode, the lesson automatically drops in audio level,

making the instructor’s voice easily understood. If the Instructor wants to have a clear channel to

speak with the students without any lesson, pause the lesson source.

2.1.1.4.3. Student Monitor

To monitor a student’s response and lesson, enter the two-digit number of the student’s headset on

the keyboard in the same manner you would with a calculator. These numbers will appear on the

digital readout. When the second digit is depressed, the student’s lesson and responses will be heard.

The Instructor’s Lesson audio will no longer be heard as long as the two digits are non-zero.

NOTE: If the student headset that is selected is not turned on or if a nonexistent student

number is selected, the console will still try to monitor the student but no audio will be

heard by the instructor. A small period to the right of the headset number will light if

that headset is transmitting and is being received properly.

2.1.1.4.4. Student Record

To record a student’s response and lesson, enter the two-digit number of the student’s headset on the

keyboard in the same manner you would with a calculator. These numbers will appear on the digital

readout. When the second digit is depressed, the student’s lesson and responses will be heard. The

Instructor’s Lesson audio will no longer be heard as long as the two digits are non-zero.

Then select a console recorder that is not being used as a lesson source and place the recorder in the

record mode. You will now record the student whose number is shown on the digital display, and the

lesson. To play back this student’s recording to the individual student, follow the instructions under

“STUDENT REVIEW”.

2.1.1.4.5. Student Review

To play back the recording of a student, press the “STUDENT REVIEW” button. Press the

“LESSON SELECT” button for the lesson channel corresponding to the tape deck that you recorded

the student on in section 2.1.1.4.4 above. Rewind the recording back to the beginning of the tape and

then enter the student headset number that was recorded (if that student number is no longer on the

display) and push the “INTERCOM W/ LESSON” button as described below. Start the tape to play

the recording to that selected student through the intercom function.

2.1.1.4.6. Intercom (ON / W Lesson)

This button permits the instructor to determine whether the lesson is present during intercom with the

student or whether the channel will be clear. The “ON / W LESSON” mode can be helpful when the

instructor wants to talk to the student and point out particular points of interest in the lesson as it is

playing.