ASSEMBLY INSTRUCTION NIGHT STAND WITH DOOR PAGE 1 OF 3
STEP 1 To remove the shelf, unscrew the shelf from shelf support using Phillips head screw driver ( NOT INCLUDED ). STEP 2 Adjust the height of shelf support. STEP 3 Align and fasten shelf support to shelf using screw and fully tighten with Phillips head screw driver ( NOT INCLUDED ).
PARTS IDENTIFICATION A. NIGHT STAND WITH DOOR HARDWARE IDENTIFICATION 1 SET 1. SHORT SCREW 1 PC 2. LONG SCREW 1 PC 3. CABLE TIE 1 PC 4. L BRACKET 2 PCS STEP 2 Locate the other bracket on the wall over a wall stud and two inches below the mounting bracket secured to the back of night stand. Attached to the wall stud using the long screw provided, through the smaller hole. This tip restraint must be attached to a wall stud using long screw enclosed.
