Assembly Instructions

ManualsBrandsFleur De Lis Living ManualsFour Person Patio Dining SetsCarleton Round 4 - Person 56'' Long Bar Height Dining Set with Cushions and Umbrella

Table Of Contents

ORLEANS4PCSW-Install.pdf
- Hanover-Install-Cover



IMPORTANT

Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),

PLEASEDONOTRETURNTOTHERETAILER/STORE

fromwhereyoupurchasedtheproduct.



Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty

Cardandreceiptforfutureuse.

For additionalon‐linesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor

OutdoorFurniture

PleasecallourToll‐FreeCustomerServiceHotlineOrvisitourwebsite.



furniture,pleasevisitourwebsite. 

Summary of content (6 pages)

PAGE 1
Outdoor Furniture IMPORTANT If you have any problems with this product (missing or damaged parts, assembly issues, etc.), PLEASE DO NOT RETURN TO THE RETAILER/STORE from where you purchased the product. Please call our Toll‐Free Customer Service Hotline Or visit our website. To expedite any future warranty claims, please retain the Instruction Sheet, Warranty Card and receipt for future use.
PAGE 2
ASSEMBLY INSTRUCTIONS 1 Position the swivel base on a flat, solid surface. Make sure the swivel plate is positioned all the way into the base. It may have vibrated out during shipment. The two sets of holes in the swivel plate should be facing away from you. Note the arrows on both the swivel plate and the "U" bar portion of the chair frame.
PAGE 3
PARTS IDENTIFICATION LIST * NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE PARTS LIST DESCRIPTION ORDER PART # QTY A CHAIR FRAME 1 B SWIVEL ASSEMBLY & BASE 1 C 5/16" X 43 MM BOLT HW0450 4 D Ø8.0 X 2.3 MM SPRING WASHER HW0003 4 E METAL PLATE HW0686 2 F 5/16" NUT HW0015 4 G BOLT COVER HW0028 4 H NUT COVER HW0109 4 I Ø8.5 X 1.
PAGE 4
ASSEMBLY INSTRUCTIONS 1 Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table legs (each leg has two bolts) through the holes in the leg connector bracket. Add a washer and a nut to the end of each bolt as shown in Fig.2. Hand tighten only 2-3 turns. Repeat on the other three legs. FOOT CAP C H E F 2 Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by using the bolts and washers as shown in Fig.1.
PAGE 5
PARTS IDENTIFICATION LIST * NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE PARTS LIST DESCRIPTION ORDER PART # QTY A TABLE TOP 1 B LEG CONNECTOR BRACKET 1 C TABLE LEG 4 D 1/4" X 18 MM BOLT HW0035 8 E 1/4" NUT HW0014 8 F Ø6.5 X 1.
PAGE 6
PARTS IDENTIFICATION LIST * NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE PARTS LIST DESCRIPTION QTY.