Owners manual

Installation Instructions

Radiator Support Channel Or Frame Installation

1. Attach frame mounting brackets to fan using the 4 3/4’’ self tapping screw.

2. Position fan to desired location, Mark holes on radiator channels or frame.

3. Rotate fan blades to ensure that they are free of obstructions.

4. On the marked hole locations, drill 13/64" holes.

5. Secure the fan to radiator using 1/4" self tapping screws.

6. Check again to be sure the fan blades rotate freely.

Electric Cooling Fan

Models 111, 123,

133, 143

rev. 05-19-08 98111 Page 1 of 3

"Dual Fan Shown"

PAGE 1
Electric Cooling Fan Models 111, 123, 133, 143 Installation Instructions Radiator Support Channel Or Frame Installation 1. Attach frame mounting brackets to fan using the 4 3/4’’ self tapping screw. 2. Position fan to desired location, Mark holes on radiator channels or frame. 3. Rotate fan blades to ensure that they are free of obstructions. 4. On the marked hole locations, drill 13/64" holes. 5. Secure the fan to radiator using 1/4" self tapping screws. 6.
PAGE 2
Wiring Instructions Model 111&133 NOTE: Models 123 & 143 do not include a fan control unit; skip to page 3 of instructions. FOLLOW THESE INSTRUCTIONS CAREFULLY TO AVOID DAMAGING THE CONTROL UNIT, FAN MOTORS, AND YOUR VEHICLE! WHEN CRIMPING WIRES, ALWAYS USE A QUALITY CRIMPING TOOL (DO NOT USE PLIERS OR OTHER DEVICES). Step 1: Locate mounting point for the control unit Locate a mounting point for the control box near inlet side of the radiator.
PAGE 3
Wiring Instructions 111&133 Cont'd. 5. Ignition controlled power source Locate fuse box. Find a circuit that is "hot " when the key is in the "ON" position. NOTE: DO NOT use the DRL or brake/taillight fuse! Attach the included fuse tap to fuse. Attach a female connector to the thin red wire included and connect to the fuse tap. Trim the wire so that it will reach the control unit. Attach a pink female connector to end of wire and connect to the "+" terminal on the control unit. 6.