Manual

Acura INTEGRA radiator fan
replaces O.E. fans • fits 1994-2000
blade Diameter 2@12"
fan Dimensions 15
1
/2" x 26
1
/4" x 2
5
/8" thick
Amp Draw 19.5
fan R.P.M. @ 13.5vdc 2000
Number Of Blades 10 x 2
Fan Blade Angle 18˚- 40˚
One fan operates using car’s on-board thermostat:
second fan activates when A/C is turned on.
tech specs
Flex-a-lite Consolidated, 7213-45th street court east, fife, Washington 98424, telephone no 253-922-2700, warrants to the original
purchaser user all Flex-a-lite products to be free of defects in material and workmanship for a period of 365 days (1 year) from date
of purchase. Flex-a-lite products failing within 365 days (1 year) from date of purchase may be returned to the factory through the
point of purchase, transportation charges prepaid. If, on inspection, cause of failure is determined to be defective material or work-
manship and not by misuse, accident, or improper installation, Flex-a-lite will replace the fan free of charge, transportation prepaid.
Flex-a-lite will not be liable for incidental, progressive, or consequential damages. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific
legal rights and you may also have other rights, which vary from state to state.
Flex-a-lite Consolidated Fife, Washington 98424 USA
Use as a Puller Fan (behind radiator) only
warranty
FAL's low-profile electric fan will provide more clearance in front of the engine for a turbo
or intercooler equipment, while improving on the air flow of the original equipment fan.
Electric connections match original connections. No splicing or additional fittings required.
1) Disconnect battery, then unplug electrical connector at both fans.
Remove both old fans. Save the screws. locate upper a/c line bracket
(in front of radiator), and remove.
2) Fasten top & bottom brackets to new FAL fan unit with 4 small screws
and
2 washers provided as shown below. Do not tighten bottom brackets yet.
3) Lower dual fan unit into place. hook bottom brackets around radiator
flange, and tighten screws to hold in place.
4a) Showa radiators only:
Place plastic spacers at mounting points (on driver's side) as shown.
Carefully align holes in upper bracket to radiator and fasten using 2 short
screws provided. If necessary, adjust lower brackets to get correct
alignment. Fasten upper bracket on passenger's side with one long screw
provided. Tighten all screws.
4b) Nippon denso radiators only:
On driver's side, align holes in upper bracket to radiator and fasten using
2 short screws provided. If necessary, adjust lower brackets to get correct
alignment. Fasten thru bent tab on upper bracket using one of the original
screws. Tighten all screws.
5) Plug in both fans. Reconnect battery.
installation
SHORT
SCREWS
PLASTIC SPACER
(SHOWA ONLY)
LONg SCREW
(showa only)
original SCREW
(denso only)
bottom
bracket
small screw
washer
radiator
flange
NOTE: Integra fan requires 2
3
/4" minimum clearance for installation.