User Manual

MAIN WING INSTALLATION
Required Tools and Fasteners: #1 Phillips Screwdriver, (4) M2x6mm self-tapping Phillips head screws,
(1) M3x70mm Phillips machine screws, (8) M3x12mm self-tapping Phillips head screws
1. Locate the (4) cabane struts, fuselage, and top wing. Dry t the cabane struts into the moulded mounts in the wing and fuselage to ensure
proper tment and alignment. The longer rods are the rear cabane struts, the shorter rods are the front cabane struts.
2. Rotate the cabane to align the screw holes in the cabane and cabane mount and secure to the upper mounts in the top wing with (4)
M2x6mm screws. Insert the interplane struts in the lower mounts on the fuselage and mark the depth that each strut inserts into the mount.
3. Remove the wing and wrap low-tack masking tape around the strut on the line marked in Step 2. Using medium (150) grit sandpaper,
roughen the lower portion of each cabane strut. Remove tape and clean struts and inside of the fuselage mounts with isopropyl alcohol.
4. Glue cabane struts into the lower mounts on the fuselage with 15-minute epoxy. FULLY SEAT CABANE STRUTS INTO THE LOWER MOUNTS
ON THE FUSELAGE AND ENSURE THEY REMAIN SEATED. Clean excess epoxy prior to curing.
5. Once the epoxy has fully cured, unscrew the top wing from the cabane struts and temporarily place it to the side.
6. Locate the bottom wing and the (2) interplane struts.
10