QQ CAP 232EX 60E Super PNP Manual

MAIN WING AND SFG INSTALLATION
14
Required Tools and Fasteners:
Remove the canopy from the fuselage by pulling the latch to the rear of the canopy and lifting the canopy from the fuselage. Insert the
main wing tube into the fuselage and roughly center.
Slide the left and right wing panels onto the tube. Ensure the servos orient to the bottom of the fuselage.
Connect the aileron servo leads to their respective extensions in the fuselage. If you have a night version, connect the wing JST to the
fuselage JST connector.
Fully seat the wing into the fuselage while being careful to align the wing mounting tab with the slot in the fuselage. Be sure to avoid
pinching any wires during this process. Secure the wing to the fuselage using a phillips screwdriver and an M3x10 washer head screw.
Place the SFGs on the wing tips, and secure them in place using a phillips screwdriver and two M5x35 nylon phillips head screws. Do
not overtighten.
1.
2.
3.
4.
5.
M3x10 Phillips Washer Head Machine Screw (2)
M5x35 Nylon Phillips Head Machine Screw (4)
#1 Phillips Screwdriver
*JST connector for Night Version Only