QQ CAP 232EX 60E Super PNP Manual

PROPELLER AND SPINNER INSTALLATION
17
Required Tools and Fasteners:
M3x8 Phillips Head Screw (1)
M8 Nut
M8 Prop Washer
1.
2.
3.
Slide the propeller onto the prop adapter with the convex surface facing forward. The propeller size numbers are molded into the front
face of the propeller and should orient forward.
Place the M8 propeller washer onto the shaft with the widest face towards the propeller. Tighten the M8 nut onto the shaft.
Place the spinner onto the shaft, being sure to seat it fully. Use an M3x8 phillips head screw, and a #1 phillips screwdriver to secure it in
place.
#1 Phillips Screwdriver
Adjustable Wrench