QQ CAP 232EX 60E Super PNP Manual

SERVICING THE POWER SYSTEM
23
Required Tools and Fasteners:
#1 Phillips Screwdriver
M3 Hex Driver
1.
2.
3.
4.
5.
Following the installation instructions in reverse, remove the spinner and propeller from the motor.
Use a #1 Phillips screwdriver to remove the cowling screws from the plastic tabs on the side of the fuselage.
Pull the plastic tabs away from the fuselage, and remove the cowling from the fuselage.
Remove the (4) bolts holding the motor to the firewall using a #1 Phillips screwdriver. Disconnect the motor from the ESC.
To remove the ESC, disconnect the ESC from the receiver or the Aura 8, and remove any cable ties holding the ESC to the fuselage.
REMOVING/INSTALLING THE PILOT
Required Tools and Fasteners:
#11 Hobby Knife
Clear Tape
1.
2.
3.
4.
Remove the canopy from the airplane.
Use a #11 hobby knife to cut through the tape holding the pilot in place. Be sure to cut only the tape.
Remove the pilot from the canopy.
To install the pilot, insert the pilot into the canopy, and tape it in place.