Mamba 60 Final Manual

11
RECEIVER INSTALLATION/SERVO CONNECTIONS
CONNECTING YOUR RECEIVER TO AURA
Supported Modern Data-linked Receivers
Aura will auto-detect these modern digital receiver connections:
Spektrum Remote Receivers
Futaba or Hitec S. Bus
Graupner HOTT (Sum D of 8)
Spektrum SRXL
JR XBus (Mode B)
Jeti (standard)
A PPM (8CH, negative shift, approximately 22ms/frame) receiver may also be
connected into port “B”, however, Aura will not auto-detect and setup must be
DEFAULT AURA CONNECTIONS
S1
S2
S3
S4
S5
S6
S7
Throttle (ESC/BEC)
L. Aileron (TOP)
L. Aileron (BOTTOM)
R. Aileron (TOP)
R. Aileron (BOTTOM)
Elevator
Rudder
Aura will auto-detect modern digital receiver connection(s). Using
a modern digital receiver connection gives the Aura access to
precise data of each channel for additional gyro-enabled outputs,
connect a modern digital receiver connection, follow the steps on
this page, then skip ahead to page 14.
Digital receiver connections
Examples of reccommended receivers:
Spektrum SRXL
AR7700
AR8010T
AR9030T
Futaba S.Bus
S-FHSS - R2001SB
FASST - R6303SB
FASSTTest - R7008SB
JR XBus
RG612BX
RG712BX
Graupner SUMD
GR-16L
FrSky S.Bus
RX6R
RX8R
1.
While Spektrum and Futaba usually output their
digital data stream, it may be necessary for
JR DMSS, Graupner HOTT, and Jeti users to pro-
gram the transmitter/receiver to output the
correct digital format listed on the previous page.
Consult your transmitter and receiver manuals
for further details.
2.
Bind your transmitter and receiver per your manu-
facturer’s instructions.
3.
Connect the included male to male servo extension
to the receiver’s data port (ex: S.Bus, SRXL, etc.) and
connect to servo port “B” on the face of the Aura.
Refer to your radio manufacturer’s instructions for
connections and system settings.
4.
With transmitter powered, power up the aircraft.
Aura will search (sweeping LEDs) and lock onto the
signal. You will then see solid orange (power and
calibrated sensor) plus solid green (valid radio source),
and have control of the model.
If your receiver has a working throttle port while using it’s
digital connection, USE IT. Move the ESC (throttle) lead from
Aura port S1 to your receivers throttle port. Consult your
details on your system.
Note: If you are using Futaba S.Bus, be sure to use the proper
S.Bus port in your receiver. DO NOT use use the S.Bus 2 port, as it
is not supported for use with the Aura 8. Refer to your
manufacturer’s instructions for proper S.Bus use.
Note: When using Spektrum SRXL to connect to the Aura,
always connect the remote receivers to the Spektrum receiver,
NOT the Aura.
recommended receivers for this aircraft, please visit the Mamba 60
Wiki page at the below URL.
S8 LED CH6/Aux1