Mamba 60 Final Manual

1. Locate the Elevator and Rudder pushrod assemblies.

RUDDER AND ELEVATOR LINKAGE INSTALLATION

Required Tools and Fasteners

2. rplane.

3. With the aircraft still powered on, install the rudder and elevator servo arms perpendicular to the servo case, being sure to orient the servo arm

towards the bottom of the fuselage. Apply a small amount of Blue Thread Lock to the M3x6 Phillips head machine screw and secure the

servo arm in place with a #1 Phillips screwdriver.

Elevator and Rudder Pushrod Assemblies

(QTY 2)

M2x10 Phillips Head Machine Screws

M2 Flat Washer

M2 Lock Nut

M3x6 Phillips Head Machine Screws

#1 Phillips Screwdriver

#0 Phillips Screwdriver

Needle-Nosed Pliers (or Hemostats)

Blue Thread Lock

WARNING

DUE TO VARIANCES IN PRODUCTION AND THE LARGE CONTROL SURFACE THROWS ON THIS AIRCRAFT PROPER SERVO CENTERING AND

TRAVEL ADJUSTMENT IS CRITICAL TO PREVENT SERVO OVER TRAVEL AND FAILURE. IF THE SERVO ARMS ON YOUR AIRCRAFT DO NOT

SIT PERPENDICULAR TO THE SERVO CASE, YOU MUST USE THE AURA CONFIG TOOL TO ADJUST THE SUB-TRIM AND/OR OUTPUT SCALE

VALUES TO PREVENT OVER TRAVEL OF THE SERVOS.