Mamba 60 Final Manual

MAIN WING INSTALLATION (CONTINUED)

Required Tools and Fasteners

Locate the lower wing panels, the short wing tube, and the M3x20 Phillips head machine screws.

Slide the wing tube through the fuselage then slide one of the wing panels onto the wing tube and connect the servo leads. It is good idea

ond wing panel

8. Locate the long wing tube, the M3x25 Philips head machine screws, and both top wing panels.

9. Slide the wing tube through the center section of the upper wing, slide one of the wing panels on, connect the servo leads and install the

M3x25 Phillips head machine screw. Repeat for other wing panel.

10.

Now that both wings are installed, locate the (2) interplane struts (or “I” struts if you prefer) and the four “I” strut retaining pins.

11.

hole at base and

top of the “I” strut. Slide the pins in to the point where you feel them “pop” into place. Rotate the pins so that the exposed part is resting

on the wing. Repeat for other side. (see page 19)

M3x25 Phillips Head Machine Screw

M3x20 Phillips Head Machine Screw (lower wing)

(QTY 2)

(4) Interplane strut retaining pins

#1 Phillips Screwdriver