Mamba 60 Final Manual

PROPELLER, SPINNER, AND BAFFLE INSTALLATION
Required Tools and Fasteners
1.
2. Place propeller adapter on front of motor. Apply a a small amount of Blue thread lock on each of the four M3x10 socket head screws.
Install them through the prop adapter and to the motor.
3.
e epoxy
4.
Locate the propeller, propeller nut, and spinner. Install the propeller on to the propeller adapter with the convex side facing forward.
Place the propeller washer over the shaft and thread the propeller nut on to the propeller adapter. Use an adjustable wrench to
tighten the propeller nut.
5.
Place the spinner over the prop shaft (propeller adapter), align the notches in spinner with the propeller blades and secure the spinner
with the M3x10 Phillips head screw and a #1 Phillips screw driver.
M3x10 Socket Head Machine Screw
(QTY 4)
Blue Thread Lock
Adjustable Wrench
15 Minute Epoxy
M3x10 Phillips Head Machine Screw
(QTY 1)
Prop Adapter
Prop Nut
#1 Phillips Screwdriver