Mamba 60 Final Manual

Flight Mode 2 - High Speed 3D

high rate. Ideal for tumbling and

Rates are high, expo adjusted high for

Gains are set low

Flight Mode 3 - Slow Speed 3D

harriers, hovering, and other slow speed

Rate in all control surfaces at max, expo

Gains are set high.

Note: Flight mode 3 should not be used to

Control surface oscillation might occur if

this mode.

Flight Mode 1- Sport

For sport or precision aerobatics.

Gains are set low.

ADVANCED MAMBA 60 AURA CONFIGURATION

ed WITHOUT

THE USE OF A WINDOWS BASED PC OR TABLET

High Speed, and Slow Speed 3D.

1. Make sure all power is removed from the Mamba 60E+. Remove the propeller for safety.

2. Turn on your transmitter. Ensure you are in the correct model memory.

3. Remove the servo lead that is in Aura Port S2.

4. Insert a bind plug into Aura Port S2

If the Green LED on the Aura is SOLID, the Aura is set to use the STOCK

If the Green LED on the Aura is FLASHING, the Aura is set to use the EXPERT

7. g the

d replace

the servo lead back into Aura Port S2.

8. Verify that all controls function, and that both transmitter direction test and Aura sensor test pass. Familiarize yourself with the new

Note: “Crow”

transmitter. Test the switch action on your transmitter’s monitor screen.

Crow is mixed in a linear fashion to the throttle. With crow activated, advancing throttle

to full will return the crow to zero. When the throttle is returned to idle, crow is once

again activated

CROW

TURNING ON “EXPERT” MODE IN AURA