Mamba 60 Final Manual

6
MAIN LANDING GEAR INSTALLATION
Required Tools, Parts, and Fasteners
Locate the landing gear, axle assemblies, wheel pants, and M4 lock nuts and washers.
Use a Phillips screwdriver to remove the M3x12 self-tapping screws from the wheel pants, and separate the wheel pant
halves from one another.
Remove the M4 lock nut and washer from the axle assembly (if required). Slide the axle through the landing gear, and place an
M4 washer over the exposed threads of the axle. Secure the axle in place using an M4 lock nut and two 7mm wrenches.
Tighten fully.
Install the inside-half of the wheel pant to the landing gear using an M3x10 Phillips head machine screw and blue thread lock.
If you wish to leave the wheel pants off the aircraft, you can skip this step as well as step 5.
Re-install the outside half of the wheel pant to the inner half using the M3x12 self-tapping screws removed in step 2.
1.
2.
3.
4.
5.
(2) M4 Lock Nuts
#1 Phillips Screwdriver
(2) M3 X 10 Machine Screw
7mm open end wrench (2)
(4) M3 X 14 Machine Screw
(QTY 2)
(QTY 4)
x2
x2
(QTY 2)
(QTY 2)
(2) M4 washers
Blue Thread Lock