Mamba 60E Aura Connections Notice

7-30-19
V1.1
Mamba 60E+ Notice & Manual Addendum
During quality assessment of the initial shipment of the Mamba 60E+, three mistakes were found.
1. It was found that the factory improperly configured the aileron servo extensions in the Aura 8. Check and verify
that your servo extensions are plugged in to the ports as shown in the chart below. If they are not configured in
this way, remove them from the Aura and configure them accordingly. This is also shown properly on Page 11
of the instruction manual.
2. It was found that the Transmitter Configuration Guide on page 9 of the instruction manual lists incorrect
information for the Wing and Tail type listed. The proper wing and tail type should be 1 aileron, 1 elevator 1
rudder.
Transmitter Configuration Guide
Spektrum, Futaba & Graupner
JR DMSS
1
Wing/Tail Type
1 Ail, 1 Ele, 1 Rud
1 Ail, 1 Ele, 1 Rud
Travel Adjust
(End Points or
ATV)
Ail/Ele/Rud - 125%
*For newer pilots with lower skill
levels, we recommend setting the
aileron travels to 112%
Ail/Ele/Rud - 88%
*For newer pilots with lower skill levels,
we recommend setting the aileron
travels to 75%
Thro/Gear - 100%
Thro/Gear - 88%
Reversing
None Required
2
None Required
Sub-Trim
Verify at zero, NOT ALLOWED
Verify at zero, NOT ALLOWED
Trim Levers
Verify at zero
Verify at zero
CH. 5 (Gear)
Assigned to 3-position switch
CH. 6 (LEDs)
Assigned to 2-position switch
Timer
Set to 5:00 for initial flights
3. It was also found that the wing mounting screws listed on page 17 of the instruction manual are incorrect. The
proper wing mounting screws are (4) M3x10 machine screws and should be included in a bag labeled “Main
Wing”
FPMADMAMBA60E
Default Aura Connections
S1
Throttle (ESC/BEC), if applicable*
S2
Left Aileron, Bottom Wing
S3
Left Aileron, Top Wing
S4
Right Aileron, Bottom Wing
S5
Right Aileron, Top Wing
S6
Elevator
S7
Rudder
S8
LED Controller (CH6/Aux 1)
*Only use throttle in S1 if your receiver does not have
a functioning throttle port.