Cessna 170 G2 60E - Manual

13
DEFAULT AURA CONNECTIONS
S1 – Throttle
S2 – Left Aileron
S3 – Right Aileron
S4 – Elevator
S5 – Rudder
S6 – Left Flap
S7 – Right Flap
S8 – Water Rudder (optional, with floats)
Port B – Serial Receiver Input
Mini Port A&B – Remote Receiver Inputs
Mini Port A
Mini Port B
Micro USB Port
Port B
CONNECTING YOUR RECEIVER TO AURA
Note: The Spektrum 4651T
receiver requires the use of a
different cable to connect to
Aura. The cable is included with
the receiver when it is purchased
directly from Flex Innovations.
You can also purchase the cable
itself at flexinnovations.com
(FPZA1039).
Spektrum Remote Receivers
If using two Spektrum Remote Receivers, connect them to
Aura Mini Port A and Mini Port B using the cable provided
with your receivers.
Serial Receivers
If using a standard serial receiver, connect the provided male to male cable to
your receiver’s serial port. Connect the other end of the cable to Aura Port B
noting proper polarity.
Note: If you are using Futaba
S.Bus, be sure to use the
proper S.Bus port in your
receiver. DO NOT use the
S.Bus2 port, as it is not
supported for use with the
Aura 8. Refer to your
manufacturer's instructions
for proper S.Bus use.
Note: When using Spektrum SRXL to connect to the Aura, always connect
the remote receivers to the Spektrum receiver, NOT to the Aura.
4651T
ESC
-
+
-
+
ESC
Binding Your Receiver
1. With the transmitter and aircraft powered OFF, place a
bind plug into Aura Port S8.
2. Power on the aircraft. Your remote receiver should flash
rapidly, indicating it is in bind mode.
3. Bind your transmitter to the remote receiver per your
transmitter manufacturer’s instructions. This is typically
done by pressing and holding the bind button on your
Spektrum transmitter while powering it on.
4. Verify the receivers are bound by looking at the LED on
the Remote Receivers. This is typically indicated by a
solid orange LED on Spektrum Remote Receivers.
5. Remove the bind plug from Aura Port S8.
Binding Your Receiver
Bind your receiver to your transmitter per your receiver and transmitter
manufacturer’s instructions.
SERVO CONNECTIONS