Cessna 170 G2 60E - Manual

PROP ADAPTER, PROPELLER AND SPINNER INSTALLATION

Required Tools and Fasteners: 2.5mm Hex Driver (3) M3x9 Hex Head Machine Screws

#1 Phillips Screwdriver (1) M3x30 Phillips Head Machine Screw

Adjustable Wrench (1) Prop Washer

Blue Thread Lock (1) Propeller Nut

Note: Do not complete transmitter, receiver and/or Aura setup with the propeller installed.

1. Locate the bolt-on prop adapter for the motor. Apply blue thread lock to each of the three M3x9 hex head machine screws, and secure the prop

adapter to the motor. Make sure that the propeller adapter seats fully against the motor face, and is concentric with the motor shaft.

2. Install the spinner backplate onto the motor shaft. Ensure that it is fully seated.

3. Install the propeller with the convex surface facing forward. The propeller size numbers are printed on the front face of the prop and should

orient forward.

4. Slide the prop washer on the shaft with the widest face aft, and tighten the prop nut.

5. Install the spinner cone, and tighten the M3x30 Phillips Head screw using a #1 Phillips screwdriver. Do not apply blue thread lock and do not

over tighten.