Installation Guide

Cutting/Machining
– WM Flex does not have to be warmed to avoid cracking or
breakage.
– WM Flex flexes and installs best when heated to around 70
o
-
80
o
to bend easier.
– Remove from box, bend backwards and heat in sun or heated
area.
– WM Flex may be cut, fitted, and fastened in the same manner
as with real wood (use conventional woodworking tools).
– IMPORTANT : SANDING THE FACE OF STAIN GRADE
MOULDING WILL REMOVE THE GRAIN TEXTURE.
Installation/Fastening
– Using adhesive, mastic, or resin epoxy glue alone produces
the best fastening results, in addition to nails.
– Best fastening way is to nail through block of wood placed
over face and remove nail and block after adhesive cures.
– Defects can occur if nails are placed too close to edges (nails
should be no closer than 3/8” from the edge).
– Glue joints and miters, and repair cracks or breaks with our
“No Nail” brand glue, or any fast cure resin or epoxy glue – DO
NOT USE WOOD GLUE.
– Do not use staples to fasten material and keep nails to a
minimum.
– If you have to work really hard to a make the moulding work in
the application, it was probably ordered incorrectly.
Finishing
1) Always wipe surface clean with paint thinner of mild solvent
2) Never paint or stain before installation
3) Fill nail holes prior to staining with plastic resin filler
– Painting
• Sand lightly to improve paint bond
• Fill imperfections with hard plastic resin filler and sand
surface flat
• All paints work well (oil based works best)
– Staining
• Fasten product without nails for best results
• Use GEL stain (or those with heavy pigments) for best
staining results
• Wipe on stain and remove excess with cloth and dry
brush light or dark
• Clear coat over stain using spray application only – do
not brush and sand between coats
• Do not brush on or sand in between coats
Flex Trim - Installation