Operation Manual

16 English
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After having completed the wet vacuum
operation clean the flat pleated filter,
the electrodes and the container and let
dry.
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Î Plug in the main plug.
Î Turn on the appliance.
Î Set the suction output (mix - max) at the
rotary switch.
Î Connect the mains plug of the electric
power tool to the vacuum cleaner (3).
Î Turn on the appliance (1).
Lamp is on - vacuum cleaner is in the
standby mode (2).
Note
– The vacuum cleaner is turned on and
off automatically with the electric power
tool.
– The vacuum cleaner starts automatical-
ly within 0.5 seconds and continues to
run for 15 seconds after the power tool
has been switched off.
– Please refer to "Technical specifica-
tions" for the power connection specifi-
cations of the power tools.
Clip connection
Operation
Turning on the Appliance
Adjust the suction output
Working with electrical power tools