Owner's manual

_____________________________________________________________________________________________________
Flex Membrane International Corp. 2670 Leiscz’s Bridge Road, Suite 400, Leesport, PA 19533
Tel: [phone] Fax: [phone] www.FlexRoofingSystems.com
Page 1
Product Data Sheet
FLEX TPO MOLDED SEALANT POCKET
PRODUCT DESCRIPTION
The Flex TPO Molded Sealant Pocket consists of an interlocking, two-piece, injection molded flexible
pocket with a rigid polypropylene vertical wall and pre-formed deck flanges. This product, in conjunction
with Flex TPO Primer and Flex TPO Molded Pocket Sealant, is used to waterproof pipe clusters or other
odd shaped penetrations on Flex TPO Roofing Systems.
PHYSICAL PROPERTIES
Size: 11.5” to 7.5” by 6” oval (29cm-19 cm by 15 cm)
Packaging: 5 pockets/carton
Weight (each): 0.75 lbs. (0.25 kg)
Material: Injection TPO Molded
Color: White, Gray or Tan
INSTALLATION:
1. Clean the inside of the Flex TPO Molded Sealant Pocket as well as the areas where the pocket
overlaps, the underside of the pocket flange and the deck membrane with Weathered Membrane
Cleaner. (Use a Scotch Brite Pad with the cleaner if the membrane has been exposed for an
extended period of time).
2. Place the Flex TPO Molded Sealant Pocket around penetration(s), overlapping the two sections of
the pocket.
3. Cut a piece of cardboard (approximately 4”x 4”) and place between the overlapping area of the
TPO Molded Sealant Pocket and the deck membrane. The cardboard prevents the pocket from
welding to the membrane when first welding the overlaps.
4. Using a hand-welder, weld the angle change in overlap area. Using the end of seam probe assists
in this process. (The hand-welder temperature setting should be between 5and 6).
5. Hand-weld the remainder of the horizontal overlap.
6. Repeat steps 4 and 5 to weld the overlap on the other side of the Flex TPO Molded Sealant Pocket.
7. Position the Flex TPO Molded Sealant Pocket so the vertical overlap is against the penetration.
This will allow proper pressure to be applied to the overlap with the 2-inch silicone roller.