SES Flexcharge USA 1217 State St., Charlevoix MI, 49720 Ph: (231) 547-9430 Fax: (231)547-5522 Manual Installation & Operation Model: NCxxLxx 12A or 30A Solid State Solar Charging Regulator and 12A Load Controller. 231 Patent #: 5,642,030 Applies Page 1 sSCLC Manual.
SES Flexcharge USA 1217 State St., Charlevoix MI, 49720 Ph: (231) 547-9430 Fax: (231)547-5522 Warnings When Installing, connect grounds, Battery+, PV+ then install the Fuse in that order. This not required however it will reduce the risk of arcs and sparks. CAUTION Ground yourself before touching the wiring to dissipate any static charge. Wear a ground strap if possible while working on the system. ALWAYS SOLDER AND WEATHER SEAL ALL system wire-wire and wire-crimp terminal connections.
SES Flexcharge USA 1217 State St., Charlevoix MI, 49720 Ph: (231) 547-9430 Fax: (231)547-5522 Features x Waterproof packaging. x Reverse battery polarity connection protected. x No RFI or EMI emissions to interfere with radio or data logging equipment. x Works on GEL, AGM, and Flooded Cell lead acid type batteries. x Available in 12A charge 12A load (NC12L12) or 30A charge and 12A load (NC30L12) x Easy to read LED indicators clearly display the controller’s status.
SES Flexcharge USA 1217 State St., Charlevoix MI, 49720 Ph: (231) 547-9430 Fax: (231)547-5522 Installation Guide x Unpack the controller and inspect it for shipping related damage. Do not wear static producing clothing when handling the uninstalled controller. If possible ground yourself before touching the terminal connections. x 12V / 24V Operation The controller is shipped ready for 12V systems.
SES Flexcharge USA 1217 State St., Charlevoix MI, 49720 Ph: (231) 547-9430 Fax: (231)547-5522 x x Pass a magnet over the Load indicator to reset the Low Voltage Disconnect circuit and to test the load. Installation complete. Wiring Diagram Page 5 sSCLC Manual.
SES Flexcharge USA 1217 State St., Charlevoix MI, 49720 Ph: (231) 547-9430 Fax: (231)547-5522 TM The Flexcharge Energy State Taper Charge Method The Energy State Taper Charge Process monitors the battery for the full charged resting voltage of the cells. There are tremendous advantages to this charge method. * Zero overcharging * Exceptionally low gassing (Up to 90% less) * Non-Destructive Micro-Equalization at each full charge * The battery’s chemical processes actually control the charging.
SES Flexcharge USA 1217 State St., Charlevoix MI, 49720 Ph: (231) 547-9430 Fax: (231)547-5522 Troubleshooting Guide Charge Section Charge LED does not illuminate while the battery is being charged. Check the fuse both visually and with an Ohm meter. (Note: Using the Blue wire and Charging indicator is optional for always ON models. It is required for dusk to dawn equipped models.) Red LED indicator is ON when it seams the battery should be charging.
SES Flexcharge USA 1217 State St., Charlevoix MI, 49720 Ph: (231) 547-9430 Fax: (231)547-5522 Operating Characteristics Parameter 12V Selected 24V Selected Regulated Peak Charge Voltage 14.25V 28.50V Charge Reconnect Voltage 13.70V 27.40V PV Voltage at Dusk - Load ON 4V 8V PV Voltage at Dawn - Load OFF 6V 12V Low Voltage Disconnect (LVD) 10.92V 21.84V Auto LVD Reset (continuous ON mode) 12.9V 25.
