Installation and user manual

SES Flexcharge USA
1217 State St., Charlevoix MI, 49720
Ph: [phone] Fax: [phone]
Page 3
sSCLC Manual.doc
Features
x Waterproof packaging.
x Reverse battery polarity connection protected.
x No RFI or EMI emissions to interfere with radio or data logging equipment.
x Works on GEL, AGM, and Flooded Cell lead acid type batteries.
x Available in 12A charge 12A load (NC12L12) or 30A charge and 12A load (NC30L12)
x Easy to read LED indicators clearly display the controller’s status.
x High efficiency charging circuitry. Insertion Loss resistance of only 0.080 Ohms on 12A Model 0.008 Ohms on
24V model.
x Field select for 12V or 24V operation. Shipped ready for 12V systems, simply cut a wire jumper for 24V
systems.
x Order with Load ON at Dusk, OFF at Dawn operation, or Load always ON.
x Low battery voltage Load Disconnect (LVD).
x Manual Load Test / LVD Reset magnetically operated switch located under the load status indicator. Easily
reset the LVD circuit after installation and test the controller’s load circuitry.
x Delayed Low Battery Disconnect to prevent disconnect during momentarily high load currents.
x Delayed Dawn sensing circuit to prevent load switching during momentarily bright light levels (i.e. Lightning
flashes, vehicle lights).
x Small enclosure 3”H x 3”W x 1.5”D + mounting feet.
Options
x Temperature Compensation
x High current special order models ( NC12L30, & NC30L30) 30 ampere charge and/or load capacities.
x Integral Digital Load Timer. Use with Dusk to Dawn Model. Starts timer at dusk then turns the load OFF after
the selected time has elapsed. Set Run times up to 7.5 hour in ½ hour increments or 15 hours in or 1 hour
increments, includes Dawn Override.
x Can also be used with the Flexcharge Programmable Timer for up to 8 event load timing.
x Integral Load Flasher circuitry. Order flash repeat times from 0.25 sec to 10 sec with ON-Times from 0.1 sec to
5 sec.