Installation Guide

Prime Sports™
INSTALLATION INSTRUCTIONS and TECHNICAL DATA
RECYCLED RUBBER FLOORING
Adhesive Coverage Rates, Moisture Limits and Traffic Limits
Coverage Rates (per gallon)
Moisture Limits
Traffic Limits & Maintenance Limits
Adhesive
Porous
Non-Porous
RH / MVER
Limits
Foot
Traffic
Heavy Foot
Traffic, Rolling
Loads
Maintenance
MS-700
135 sq. ft.
160 sq. ft.
95% / 10 lbs.
8-12 Hours
24-48 Hours
48 Hours
U-705
135 sq. ft.
160 sq. ft.
100% / 25 lbs.
8-12 Hours
24 Hours
24 Hours
Brushed &
Rough Porous
Smooth Porous &
Non-Porous
EW-710
120 sq. ft.
135 sq. ft.
90% / 6 lbs.
8-12 Hours
24-48 Hours
72 Hours
SUBSTRATE, INSTALLATION & MAINTENANCE INFORMATION
1. PRODUCT LIMITATIONS
 Prior to acceptance of this document refer to our
website: www.flexcofloors.com to confirm that you
have the most current revision.
 Due to the recycled nature of this product, color
variation can and will be present from piece to piece
and roll to roll.
 Material contains skive marks from the
manufacturing process on the surface. We do not
consider this defective; if the marks are not
acceptable, do not install material. Installation of
material signifies acceptance of the material.
 Deliberate damage in baseball dugouts, ice rinks
dugouts, ice rink penalty boxes, ice rink access
points, etc. is not covered under the product
warranty.
 Do not install materials over LVT, cushioned vinyl,
hardwood flooring, cork, rubber, or asphaltic
materials.
 Long term, extended or excessive exposure to
chlorine or pool chemicals can cause discoloration
or other undesirable effects
 Do not install in residences and in or around
commercial kitchens or areas that may be exposed
to oil, grease, lubricating oils, solvents and other
petroleum based hydrocarbons.
 Do not allow product to be directly exposed to
extreme heat sources, such as radiators, ovens or
other high-heat equipment. As prime sports floor
ages, the color will darken with exposure to
environmental elements; some shading should be
expected with repairs from attic stock material.
 Do not install in areas that may be subjected to
sharp, pointed objects, such as stiletto heels, cleats
or spikes.
 When installing in areas that may be exposed to ice
skates, ensure skate guards are worn.
 When installing in areas where free weights and
dumbbells over 50 lbs. will be used, ensure material
is at least 3/8" thick.
 Not recommended for basketball or volleyball
playing surfaces.
 All installations of 5/32” & 1/4” Interlocking must be
fully adhered indoors and all thicknesses outdoors.
 All thicknesses of Square Edge must be fully
adhered both indoors and outdoors.
 Material installed in heavy glass filtered light areas
should have adequate fresh air or circulated air
ventilation to reduce potential odor.
 May be susceptible to staining from rubber tires,
casters or rubber-backed walk-off mats, as well as
harsh disinfectants, cleaning agents, dyes or other
harsh chemicals – ensure all chemicals and
materials that may come in contact with flooring
surface will not stain, mar or otherwise damage the
flooring material prior to use.
2. PRE-INSTALLATION
 Consult all associated product literature concerning
adhesive installation, maintenance and warranty
prior to installation of flooring.
 Allow all trades to complete work prior to installation.
 Deliver all materials to the installation location in its
original packaging with labels intact.