Installation Guide

Flexco Floors | 1401 E. 6th St. - Tuscumbia, AL 35674
P: 800.633.3151 | flexcofloors.com | Made in the USA
08.13.2017 | Page 1
TECHNICAL DATA SHEET
TRIMS, TRANSITIONS & OTHER
ACCESSORIES
Accessories
Flexco Accessories provide a wide
variety of vinyl trims, mouldings,
transitions, reducers, edge guards,
thresholds and adapters, in addition
to stair nosings, corner guards and
cove caps. Vinyl transitions are meant
to complement the wide variety of
flooring options that Flexco provides in
coordinating colors and thicknesses to
offer a complete product offering for all
flooring installations. Accessories offer
protection for flooring and walls, whether
for a transition between flooring surfaces
or for the protection of flash cove, wall
corners or stairs noses.
• Non-Porous Material
• Economical
• Extremely Durable
• ADA Compliant
Features
ASTM E84 - Surface Burning:
ASTM E648 (NFPA 253) - Critical Radiant Flux:
ASTM E662 (NFPA 258) - Smoke Density:
Acclimation Time:
Storage & Acclimation Temperature:
Class A
Class I, > 0.45 W/cm2
Passes, <450
48 Hours
65° - 85° F
Product Description
Technical Data
Approved Adhesives - Stair Nosings & Landing Trim
EN-610 Epoxy Nose Filler Adhesive
Approved Adhesives - All Other Accessories
EN-610 Epoxy Nose Filler Adhesive
C-630 Contact Adhesive
Approved Hard Setting Adhesive
Availability, Cost & Samples
Flexco products are sold through distribution. To locate the
nearest distributor, visit flexcofloors.com or send an e-mail to
[e-mail].
Technical Documents & Support
Additional product resources and technical documents are
available online at flexcofloors.com. For additional technical
support, send an e-mail to [e-mail].
Additional Information
1. PRE-INSTALLATION CHECKLIST
• Consult all associated product
literature concerning adhesive
installation, maintenance and
warranty prior to installation of
flooring.
• Allow all trades to complete work
prior to installation.
• Deliver all materials to the installation
location in its original packaging with
labels intact.
• Do not stack pallets to avoid damage.
• Remove any plastic and strapping
from product after delivery.
• Inspect all material for proper type,
color and matching lot numbers if
appropriate.
• Ensure that all adhesives intended for
installation are approved for use with
accessory material.
• Ensure installation area and material
storage temperatures are between
65° F (19° C) and 85° F (30° C) for
at least 48 hours before, during and
after installation.
• Ensure HVAC system is operational
and fully functioning at normal
operating conditions.
• Turn off radiant-heated flooring
systems 48 hours prior to installation.
48 hours after installation, gradually
increase the temperature over the
course of 24 hours to a maximum
temperature of 85°F (29.5° C).
• Protect installation area from extreme
temperature changes, such as heat
and freezing, as well as direct sunlight
for at least 48 hours before, during
and after installation.
• Do not proceed with installation until
all conditions have been met.
2. PRODUCT LIMITATIONS
Do not install accessory materials over
existing wall base, accessories, rubber,
vinyl or linoleum flash-cove, cork,
or asphaltic materials. Do not install
accessories in outdoor areas and in or
around commercial kitchens. Do not
install in areas that may be subjected
to sharp, pointed objects. Do not allow
product to be directly exposed to extreme
heat sources, such as radiators, ovens or
other high-heat equipment. Accessories
may be susceptible to staining from
harsh disinfectants, cleaning agents,
dyes or other harsh chemicals – ensure