QR 6619600
Observe! The sensor set-up depends on pallet size.
Function description Pre-stop position The module is divided into Pre-stop position and Process position. Process position Pre-stop position The Pre-stop position is relieving the process position from the queue-pressure. The RFID-reader at the Prestop identifies the pallet, enhancing the efficiency as pallets with another destination quickly pass the Process position. Process position The Process position receives one pallet at a time from the Pre-stop.
Initiators and actuators A3 B1 A1 B2* A2 B2* B3 B4 B10 Initiators Actuators B1 Pre-stop B2 In position B3 Locking Up B4 Locking Down A1 Pre-stop. Single acting. A2 Stop. Single acting. A3 Lifting. Double acting.
Interfaces Initiator cable connector type B1: M12-connector, 3-pin B2: M12-connector, 3-pin B3: M12-connector, 3-pin B4: M12-connector, 3-pin B10: M12-connector, 3-pin (AS-i) Note: Sensors placed inside the housing is equipped with sensor cables (with the given connector type above), reaching outside the housing.
Spare parts list Standard Des.
Cylinder details Cylinder A1 ”Pre-stop” Type: Single acting Function: Pressurized: Releases the pallet flow No pressure: Blocks the pallet flow For security reasons, the pallet stop is blocking the flow in case of a pressure drop, preventing pallets from travelling uncontrolled along the conveyor. The stop should not re-block the flow while a pallet puck is in a position where it could be clamped. Cylinder A1 It is recommended to re-block the flow after each pallet.
Sensor details Sensor B1 ”Pre-stop” Type: Proximity switch, inductive Position: Placed together with Pre-stop. Function: Detects the initiator plate of the pallet before the pallet is stopped and stays active until the pallet leaves the stop. The reason why the pallet is detected by the sensor before the pallet hits the stop, is to enchance the efficiency of the pallet flow. As the pallet is detected in advance, the controller has time to take a decision whether or not the pallet should be stopped.
Mechanical spare parts C4 C1 C5 C2 D1 C3 C6 No. Flexlink No. Std name/Order No./Dimensions/Mtrl C1 = 5110106 – Plan bearing, TFF 010090, D=Ø10mm, L=9mm, Steel C2 = 5110104 – Plan bearing, TFF 08100, D=Ø8mm, L=10mm, Steel C3 = 5110107 – Plan bearing, TFF 02016.5, D=Ø20mm, L=16.5mm, Steel C4 = 5110058 C5 = 5110057 C6 = 5110110 – Festo Cylinder, ADN-32-250-A-P-A Service / Maintenance D1 = 5110059 (4 shafts) needs to be cleaned with alcohol and relubricated after approx.
Pneumatic drawing X85 Pallet
