User Manual

ManualsBrandsFlexLink ManualsEquipmentXL (65 Ð¼Ð¼) ÐÐ¾Ð½ÑÐ°Ð¶ ÑÐ¸ÑÑÐµÐ¼Ñ ÐºÐ°Ð¿ÐµÐ»ÑÐ½ÑÑ Ð¿Ð¾Ð´Ð´Ð¾Ð½Ð¾Ð²

Information from FlexLink Systems No. 97-08-29

Drip tray system

Installation and assembly guidelines

Drip tray assembly

This Technical Bulletin contains guidelines describing

how to install a complete FlexLink drip tray system. For

further information about the products, please see the

FlexLink main catalogue.

The specifications, constructional data and illustrations contained in this bulletin are not binding. We reserve the right to make alterations without prior notification.

FlexLink Systems, S-415 50 GÖTEBORG, Sweden. Tel +46⋅31⋅337 31 00. Telefax +46⋅31⋅3372233

Technical bulletin

Summary of content (4 pages)

PAGE 1
Technical bulletin Information from FlexLink Systems No. 97-08-29 Drip tray system Installation and assembly guidelines Drip tray assembly This Technical Bulletin contains guidelines describing how to install a complete FlexLink drip tray system. For further information about the products, please see the FlexLink main catalogue. The specifications, constructional data and illustrations contained in this bulletin are not binding. We reserve the right to make alterations without prior notification.
PAGE 2
Introduction This assembly instruction applies to the following drip tray system components: • X_DT – drip tray • X_DV – drip pan for vertical bend • X_DH – drip pan for horizontal bend • X_DC – end cap for drip tray • X_DE – end pan for drip tray • X_DD – end pan for idler end unit • X_DJ – drip tray connector • XHDS – drip catcher Using drip trays as a safety guard The XLDB 21×100 drip tray bracket is equipped with a key hole function.
PAGE 3
Assembly X_DT and XHDS cutting lengths X_DT How to use the table: The following instruction applies to drip tray X_DT. 1 Measure the length of conveyor beam X_CB or X_CB_N, under which you will mount the drip tray. 2 In the table, look up the products that will be mounted adjacent to the drip tray. Read the value where the row and the column corresponds. 3 Add the values from the table to the total length of the conveyor beam, as measured in step 1.
PAGE 4
X_DC, X_DE and X_DJ X_DV The following instruction applies to all X_DC, X_DE and X_DJ drip pans. The following instruction applies to all X_DV drip pans. 1 Attach square nuts to the drip pan and tighten them loosely. (Use one pair with X_DC and X_DE, two pairs with X_DJ.) 2 Insert the square nuts into the T-slot of the drip tray. 3 Adjust the position of the drip tray.