Use and Care Manual

PLAN FOR SUCCESS
4
PREFER A VISUAL WALKTHROUGH?
Scan the code below or visit flexsteelstore.com/Assembly
If you’re building a chair, loveseat or sofa, proceed to the next page.
If you’re building a sectional, go to page 10.
Figure 1.
Back
Sides
Front
Figure 2.
1. Setting Flex up in the place you want it to reside will reduce the need to move
it once it’s assembled. Open all seat boxes and lay them out where you want
your furniture to go.
3. Insert your J-Brackets into the white markers on all backs, arms, and corner
backs so that they’re ready to be dropped in when you get to their steps.
(See figure 2.)
(See gure 1.) Note: Each seat base has two side rails – these are the sides of the
seat box, while the non-railed sides are the front and back
2. Open all back, arm, and corner back boxes .