2-Panel Shower Kit Install Instructions For missing items do not return to store. Please call 877-941-3662 (Monday – Friday 8:00 a.m. – 5:00 p.m MT) V.
-wall Shower Surround Instructions Splendor Series Elegance Series Neo-Angle/Neo-Round Models: FLX40407821 Rectangular 2-wall Models: FLX48367821 D F F D I C B A C E B A E I J J Item Description Qty Item Description Qty A Back wall panel 1 A Back wall panel 1 B C D E F I J Side wall panel Left wall front mitered trim Left wall top mitered trim Right wall front mitered trim Right wall top mitered trim Corner shelf with bracket Inside corner reinforcement 1 1 1 1 1 1 1 B C D E
Required Tools Helpful Tools Installation Kit Your shower surround kit includes eight cartridges of adhesive and two cartridges of color-tinted 100% silicone. Refer to section 2B of these instructions for adhesive usage guidelines. x8 Construction Adhesive x2 100% Silicone Before Starting Consult your local building codes with questions on installation compliance standards.
Install Instructions 1. Installation of Inside Corner Reinforcement (J) A. Flashing Tape Corner Reinforcements go behind the panels in the back vertical corners for added leak protection. This tape has been cut to length, matching the height of the panels of your kit. B. Apply a bead of adhesive onto both walls about 3/4 inch away from the corner. Fold the flashing tape at the center crease with the print side together, then press the tape into the corner using a taping or putty type blade.
NOTE: It is not necessary to cut the top edges of panels to be level, as they will be covered by trim moldings. For right-hand plumbing B. For each hole to be cut, measure the vertical distance between the center of the plumbing fixture and the shower base. Measure the horizontal distance between the center of the fixture and the installed back wall panel. Mark the center of the fixtures on the face of the panel. C. Using a drill, make a small pilot hole in marked locations.
B. Place horizontal left wall top mitered trim (Item D) in place, push into the corner against back wall panel, then level it. Mark a level line on the wall on the top side of the trim molding near the outer end. Set aside this trim piece. C. Measure from the floor to the level mark made in 4.B to determine the length needed for the vertical trim molding piece (Item C). Cut vertical trim molding piece (C) to this length, but do not cut from the pre-mitered end! D.
5. Installation of Corner Shelf (I) NOTE: Corner shelf includes a folding-triangle metal bracket with screw holes which is designed to mount directly to the FlexStone wall panels. Be sure to peel away protective masking from the installation area before securing the bracket. A. Position corner shelf bracket in desired corner at desired height. Use a level to mark level lines in pencil. Adjust the alignment to include a slight forward slope for water runoff. B.
