Installation & Assembly

A. Place horizontal left wall top mitered trim (Item D) in

place, push into the corner against back wall trim piece, then

level it. Mark a level line on the wall on the top side of the

molding near the outer end. Set aside this trim piece.

B. Measure from the oor to the level mark made in 6.A to

determine the length needed for the vertical trim piece (Item

C). Cut vertical trim piece (C) to this length, but do not cut

from the pre-mitered end!

C. Fit vertical trim piece (C) over panel and plumb using a

level. If contour cutting this molding to match the tub shape,

do so now. You can scribe the contour with a compass, or by

hand, and cut with a jig saw or utility knife. For tub instal-

lations, the back side of the molding will not be supported

by panel material in the contour cut region outside the tub.

Use a piece of cuto scrap as a ller behind this area of the

molding. Peel away protective masking from the trim, apply

adhesive and adhere molding to panel. Secure with masking

tape as in Step 5.C.

D. Measure horizontal distance from back wall molding

piece to the tip of miter on the vertical molding. Cut the

horizontal top trim molding (Item D) to this dimension by

cutting o the end opposite the miter. Be sure not to cut

the mitered end.

E. Dry t the molding (D) in place for a tight t. Peel away

protective masking from the trim, apply adhesive on the

backside of the molding and adhere to the wall as before.

Make any minor adjustments necessary to ensure that the

mitered end makes a tight joint.

F. Repeat 6.A-6.E for the opposite wall trims (E, F).

Vertical trims installed to top of tub

Contour cutting the trim molding to match

the tub shape gives a professional look

Vertical trim installed outside tub,

and contour cut to match tub shape

Note: Vertical trim moldings are designed to be installed just outside

the tub, running down to the oor, and contour cut to match the tub

front shape. Optionally, trims can be cut short to rest on top of the

tub.

6. Installation of Side Wall Trims (C,D,E,F)

– 6 –

V.3 06/2021