3-Panel Shower Kit Install Instructions For missing items do not return to store. Please call 877-941-3662 (Monday – Friday 8:00 a.m. – 5:00 p.m MT) V.
3-wall Shower Surround Instructions Elegance Series Royale Series Alcove Shower Model:FLX48367831 Tub/Shower 3-wall Model: FLX60367831 (for tubs OR showers) G G D D F C C B A F B A E B I I J Item Description A B C D E F G I J Back wall panel Side wall panel Left wall front mitered trim Left wall top mitered trim Right wall front mitered trim Right wall top mitered trim Back wall top trim Corner shelf with bracket Inside corner reinforcement J K Qty K Item Description A 1 B C D E F
Required Tools Helpful Tools Installation Kit Your shower surround kit includes eight cartridges of adhesive and two cartridges of color-tinted 100% silicone. Refer to section 2B of these instructions for adhesive usage guidelines. x8 Construction Adhesive x2 100% Silicone Before Starting ! Consult your local building codes with questions on installation compliance standards.
Install Instructions 1. Installation of Inside Corner Reinforcements (J) A. Flashing Tape Corner Reinforcements go behind the panels in the back vertical corners for added leak protection. This tape has been cut to length, matching the height of the panels of your kit. B. Apply a bead of adhesive onto both walls about 3/4 inch away from the corner. Fold the flashing tape at the center crease with the print side together, then press the tape into the corner using a taping or putty type blade.
! 3. Adhesive Usage Guidlines: • 3 tubes for back panel • 1-2 tubes for each side panel • 1-2 tubes for corner reinforcements, trim, and corner shelf. Installation of Wet/Plumbing Wall Panel (B) NOTE: You will be able to fine tune your panel to a more accurate fit after the holes are cut and your panel can be firmly pushed into the corner. Inside Wall A . Hold side panel as close to plumbing wall as possible.
5. Installation of Tub Leg Filler Panels (K) A. Tub Leg Filler panels (K) are installed from the floor to the bottom of the side walls next to the skirt of the tub, only when the side walls extend beyond the tub. First trim the height to fit from floor to the bottom of the side wall panel. For a professional look, filler panel should match the contour of the tub. You can scribe the contour with a compass, or by hand, and cut with a jig saw or utility knife.
. Installation of Side Wall Trims (C,D,E,F) NOTE: Vertical trim moldings are designed to be installed either: 1) resting on top of the shower base threshold, or 2) outside the threshold and running down to the floor. Depending on the size of your alcove opening, you may even choose to contour cut the trim moldings to overlap the threshold partially. A. Place horizontal left wall top mitered trim (Item D) in place, push into the corner against back wall trim piece, then level it.
. Installation of Corner Shelf (I) NOTE: Corner shelf includes a folding-triangle metal bracket with screw holes which is designed to mount directly to the FlexStone wall panels. Be sure to peel away protective masking from the installation area before securing the bracket. A. Position corner shelf bracket in desired corner at desired height. Use a level to mark level lines in pencil. Adjust the alignment to include a slight forward slope for water runoff. B.
