Use And Care Manual

Flexzilla Pro Mini Impact Wrench

Please read the instructions carefully before initial use.

Machine type(s)

• This product is designed for installing and removing threaded fasteners in wood, metal and plastic.

No other use permitted. For professional use only.

• Please read the instructions carefully before starting the machine.

Operation

• Fix the accessories properly to the tool.

• Connect device as shown in Fig. 01 to a clean and dry air supply.

• To start the machine, pull the trigger (A). Machine speed increases by increasing pressure on the

trigger. Release the trigger to stop.

• To switch rotation, push the switch (B) as shown in Fig. 03.

• Use the reverse switch (B) only when the drive spindle comes to a complete stop. Changing the

speed before the drive spindle stops may damage the machine.

• To adjust output power, turn the regulator (C) as shown in Fig. 03.

Lubrication

Motor Clutch

• Use an air line lubricator with air tool oil, adjusted to two drops per minute. If an air line lubricator

cannot be used, add air motor oil to the inlet once a day.

Maintenance instruction:

• Dry the filter and the air inlet of the tool.

• Lubricate the quick connect coupling to prevent blocking.

• Air tools require lubrication throughout the life of the tool. The air motor and bearing uses

compressed air to start the tool. The moisture in compressed air will rust the air motor; you must

lubricate the motor daily.

• Avoid storing the tool in a location subject to high humidity. If the tool is left as it is used, the residual

moisture inside the tool can cause rust.

• Before storage, lubricate tool and run it for a few seconds.

Disposal

• All damaged, badly worn or improperly functioning devices MUST BE TAKEN OUT OF

OPERATION.

• Repair only by technical maintenance staff.

WARRANTY

LEGACY MANUFACTURING COMPANY ("LEGACY") warrants that this equipment will be free from

defects in material and workmanship for a period of one (1) years from the date of purchase, under

normal use.* LEGACY’S sole obligation under this warranty is limited to replacing or repairing, free of

charge, any equipment that proves to be defective under normal conditions and use according to the

recommendations of LEGACY. To obtain repair or replacement, the equipment must be shipped to a

LEGACY authorized Warranty and Service Center during the warranty period, transportation charges

prepaid, with proof of date of purchase. In the event of repair or replacement, the warranty period shall

not be extended beyond the original warranty period.

applies in particular to trademarks, model denominations, part numbers and drawings. Use only

authorized parts. Any damage or malfunction caused by the use of unauthorized parts is not covered by

Warranty or Product Liability.