CEILING FAN
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER THANK YOU FOR YOUR PURCHASE Thank you for purchasing this quality product. To ensure correct function and safety, please read and save all instructions before using the product SAFETY TIP 1. To avoid possible electric shock, turn off the electricity at the main fuse box or circuit panel before you begin the fan installation or before servicing the fan or installing accessories. 2.
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Blade Bracket Screw(18PCS) Metal Washer(4PCS) Mounting Screw(2PCS) 3g 3g 3g Fastener Washer(4PCS) Balanced parts package(1PCS) Wood Screw(2PCS) Mounting Screw(2PCS) Lock Washer(2PCS) Wire Nut (3PCS) Mounting bracket black white green Remote control (1PCS) Fan-motor assembly Glass Blade (6PCS) Pls check whether above accessories are completed or not?Yes,and install.
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Outlet box 3 washers Screws
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Finish
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER FROM POWER SOURCE AC 110- 120 VOLT 60Hz .
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Finish
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Remote controller GENERAL INFORMATION two Ad FAN MUST BE KEPT AT THE HIGH SPEED
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Remote controller GENERAL INFORMATION 6 8 7 1 hour / 4hour / 8hour. (not included) 6. ON/OFF the light 7. Natuarl wind (The fan speed automatic cycle between 1 to 6 speed) 8.
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Press and release reversible switch button from transmitter to control fan direction: forward or reverse.
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER [5.12in] size of product [14.07in] [7.44in] [12.66in] 7.34in [2.20in] D 0.83in x L 6in [9.
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER TROUBLESHOOTING GUIDE Table of Contents 1. 2. 3. 4. Fan / Remote is not working Fan is noisy Fan Wobbles Light is not working Please refer to the instruction sheet for detailed directions and descriptions of installation steps and requirements. 1. FAN / REMOTE IS NOT WORKING Ensure the remote is within the 20 foot range of the receiver To reset the remote control: 1) Turn off power to fan using the wall switch or circuit breaker.
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 3. THE FAN WOBBLES Verify all blades and blade bracket screws are secure (most fan wobble problems are caused by loose parts). Once fan is properly installed, run the ceiling fan for 10 minutes to let the fan self-adjust. If wobble occurs a er running the fan for 10 minutes, verify blade level using the following process: a) select a point on the ceiling above the p of one of the blades.
F8218/F8220 Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AFTER INSTALLATION WOBBLE” The fan blades have been adjusted in the factory to minimize any wobble NOTE:CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE MOUNTED ON A RUBBER CROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE CEILING, IT WOULD CAUSE EXCESS VIBRATION.
