Instructions / Assembly

Installation & Operating Instructions for the
Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Optional Wall Mounting for Transmitter Holder
Place in accessible area of your home, and screw the
transmitter holder into wall using the two screws
provided,slide hand unit into holder.
TROUBLE SHOOTING GUIDE
1.Fails to operate
a. Power to receiver ?
b.Receiver wired correctly ?
c.Fan manual speed control in highest position ?
d.Light kit switch turned on ?
e.Good battery in the transmitter ?
f. Code set at exact same positions in both transmitter and receiver ?
2.Won' t operate at distance
MAX. Motor amps: 1.0
MAX.Light watts: 180-(incandescent, or ballast non-dimmer, or LED)
NO
Yo
T
ur
I
c
C
ei
E
lin
!
If transmitter operates fan/light kit when up close,but not at 20 feet away.
Try placing the brown antenna wire higher,up through ceiling/outside the junction box.
g fan and light kit assembly must meet the following requirements:
1.Do not use with solid state fans.
2.Electrical rating:
120v 60Hz 3.5A
WARNING
TO REDUCE THE RISK OF SHOCK, THIS FAN MUST BE INSTALLED WITHAWALL CONTROL/SWITCH.
Learning code matching mode is used between REMOTE CONTROL
Setting the codes on the receiver:
and receiver. Turn on the supply power within 5 seconds and press the REMOTE
CONTROL"FAN OFF" button for 3 seconds, it can load normally after hearing a
long sound "bee", which means learning successfully and it can works normally.
(PS: Learning mode is not accepted after turn "ON" the supply power for 5
seconds)
CANOPY
RECEIVER
(FIG.4)
ANTENNA PUT AT OUTSIDE
OF CANOPY BOX CAN GET
MORE OPERATION
DISTANCE
LIGHT MUST BE KEPT AT THE ON POSITION
Light watts: <100W
AC N
AC L
MOTOR W
MOTOR V
MOTOR U
AC IN L
AC IN N
GROUND
Remote controller
GENERAL INFORMATION
INSTALLING RECEIVER IN CEILING FAN
A.Safety precautions:
MAX. Motor watts: 24V 35W
WARNING:HIGH VOLTAGE! Disconnect power by removing fuse or switching off circuit breaker.
Do not use with solid state fans.
Electrical wire must meet all local and national electrical code requirements.
B. Electrical rating:
100V-240VAC 50/60Hz
C.Installing receiver in fan:
a.Remove power from the circuit.
b.Remove ceiling fan canopy from the mounting bracket.
c.Disconnect existing wiring between ceiling fan and supply in electrical junction box.
d.Make connections as follows, using the wire nuts supplied:
OPERATING TRANSMITTER:
A. Install LR03/AAA 1.5V*2 volt battery(not included).
(To prevent damage to transmitter, remove the battery
if not used for a long time )
B. Store the transmitter away from excessive heat or humidity.
C. Operating the buttons on the panel of the transmitter.
Light er-
Time 2
War m white
Natual wind
F owar d/Reve rse
Light ON/OFF
Time 30 min.
Natual white
Pure white
Light er+
30'