F8301110V
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Sicherheit information TECHNICAL INFORMATION SKU F8301110V light 120V AC 35W 1*3CCT integrated LED MAX.
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER Mounting screws (2 PCS) Blade screws (1 PCS) Wire nuts (9 PCS) Washer (2 PCS) Mounting bracket Canopy REMOTE CONTROL (1 SET) Canopy cover Coupling cover 6”Ball/downrod assembly (pre-assembly) 10” downrod Hanging Pin “R” Locking Pin Blade (6 PCS) Light kit plate Light kit assembly Pls check whether above accessories are completed or not.Yes,and install.
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 1 Outlet box Securely attach the mounting bracket to the outlet box, using the self tapping screw and the washers. Mounting Bracket washers Self tapping screw X2 X1 2 Remove "R"locking pin and hanging pin; remove the cross pin on the ball and the pre-assembled screw.
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 5 Slide canopy cover and canopy over the downrod. 6 X1 7 8 Tighten the screw on the ball. Hang the fan onto the mounting bracket in the right position. Insert receiver into hanger bracket with the flat side of the receiver facing the ceiling.
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 9 Connect the wires ITE WH E BLU YELLOW RED GRE Y WH ITE BL UE YELL OW FOR LIGHT RED 10 TO MOTOR AC IN L AC IN N L N Remove 1 of the 2 screws from the bottom of the mounting bracket, and loosen the other one; Slide the canopy up towards the mounting bracket and place the key hole on the canopy over the screw on the mounting bracket, then turn canopy until it
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER 12 Attach one fan blade with 3 blade screws, and repeat for all 6 blades. X6 X18 13 Remove 3 light kit plate screws. X3 14 Attach the light kit plate to the motor assembly, and tighten with 3 light kit plate screws.
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER INSTALLING THE BATTERY Remove the back cover on the transmitter and install a 12V battery (not included) with the remote control. LEARNING PROCESS NOTE: After turning the AC power back on, do not press any other button on the remote control before pressing the button.
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER size of product 13.25”or17.25” 6.75” 6”or10” 2.
F8301110V Installation & Operating Instructions for the Owner's Installation ,Manual WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AFTER INSTALLATION WOBBLE” The fan blades have been adjusted in the factory to minimize any wobble NOTE:CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE MOUNTED ON A RUBBER CROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE CEILING, IT WOULD CAUSE EXCESS VIBRATION.
