User's Manual

User Manual - CC1W
Page 12 of 21 DOC No. 0095771
4. Operation
1. Disconnect or turn off power to the base unit.
2. Ensure the base antenna is connected.
The remote’s antenna is installed by the manufacturer; to preserve safety certifications, it
is not intended to be removed.
3. Ensure the manufacturer-supplied battery is connected to the remote unit.
4. The remote unit’s indicator LED, if viewable, will flash about twice per second.
5. Connect or turn on power to the base unit.
6. The base and remote will connect on the last-used radio channel in about a second.
7. If the base is set to use an alternate channel, it will switch the remote to that channel.
This only takes a few seconds.
8. Normal operation begins.
A reconstructed version of the 0-10mV or 0-20mV nominal load cell output will appear at
the base output.
9. As shown on section 4.1 on this manual, if radio interference occurs, an alternate channel
may be selected.
Caution! To preserve safety certifications, do not attempt to remove the remote
from its housing in order to view the LED.