Manual

DAD 141.1 Technical Manual, Rev. 2.2 - February 2014
Page 23 of 54
7.11. Error Codes
Zero key is not enabled (chapter 7.3, menu 1.1)
Out of zero range.
(You are trying to setazero which is greater than ±2% of the upper display limit)
N/A
Input exceeded ± 3.3mV/V
Load cell connection fail
Requested value out of range
Display overload – see menu 3.1o
Display underload – see menu 3.1u
The Zero or Tare motion limit has been exceeded. Set Zero or Tare function
disallowed. Review Zero and Tare motion limits set in menu 4.4.