User guide

FLINTEC
Document Date Code Rev. Page
FDT – VERSION A/B – TECH. -REFERENCE MANUAL 05.04.99 FDT.RM 2
10
of 23
SETUP 2 (SERIAL PORT 2 / PRINT PARAMETERS)
2.t PRINT TYPE : 00 PORT DISABLED.
01 TICKET PRINTOUT (Date, time, Nr, weight).
02 CONTINUOUS TRANSMISSION OF WEIGHT.
05 TICKET GROSS, TARE, NET, (quadruple size).
06 SINGLE LINE NUMBER AND GROSS, TARE, NET.
09 HOST COMPUTER MODE.
20 CUSTOM PRINTS . Format 1 in Gross (Max 512 b).
Format 2 in Net (Max 512 b).
2.d DATA BITS SERIAL CHANNEL 1 17 = 7 data bits / even parity
08 = 8 data bits / no parity
2.E ADDRESS OF FDT–52 (A-Z)
2.L PAGE LENGTH Ticket length in linefeeds
2.r PAPER REVERSE Number of reverse linefeeds before printout
2.A LEFT MARGIN Number of spaces from left margin
2.F PAGE HEADER Number of linefeeds before printout
2.1 RESERVED
2.2 RESERVED
2.3 PRINT BELOW / 0=NO 1=YES Printing is inhibited if the weight is less than
MIN. CAPACITY min (20 scale division) and the display show
Lo CAP briefly.
2.4 RESERVED
2.5 RESERVED
2.6 WAIT UNLOAD 0=NO 1=YES Inhibits further prints until the weight falls
below min.
2.7 PRINTER ERROR / 0=NO 1=YES Printer error or paper out will display Err 20
CONTROL and transmission will be inhibited.
2.8 RESERVED
SETUP 3 (SERIAL PORT 1 & MODE)
3.t MODE OF OPERATION 01 = Remote display for continuous weight input.
Use I to select Instruments (LECW_1 protocol ie. P + 12.345 CR)
and P to accept 02 = FAD mode – Master. Polls FAD’s connected and displays
and proceed. FAD data.
03 = FAD mode – Slave. Displays data from FAD. Polling of
the FAD’s must be done by another Master
(FDT or PC).
04 = Dual FAD mode – Master. SCALE A/B.
3.b BAUD RATE 24 = 2400 baud 38 = 38400 baud
Use I to select 96 = 9600 baud 57 = 57600 baud
and P to accept 19 = 19200 baud 11 = 115 kbaud
and proceed.
3.d DATA BITS & PARITY 08 = 8 data bits, no parity
Use I to select 17 = 7 data bits, Even parity
and P to accept
3.n NR OF POLLED FAD; Key in the number of connected FAD’s (decimal 01–63)
Polling always starts with address A (41h or 65d).
3.E FAD DISPLAY ADDRESS Use “DIGIT ENTRY” to key in the FAD address to be
displayed (65–127) by the FDT (decimal).