Instruction Manual

ManualsBrandsFlintec ManualsHardwareFRD-45 LCD

... the right weigh

FRD-45 BL Manual page 1 of 8

45 mm LCD Numerical Display

MANUAL

Release 10.11.2006

This manual was created with special care on the technical content and the correct

verbalisation. However, as a matter of principle Flintec GmbH will not take

responsibility for any damage caused by missing or wrong informations

FRD

–

45 BL

Summary of content (8 pages)

PAGE 1
... the right weigh 45 mm LCD Numerical Display FRD – 45 BL MANUAL Release 10.11.2006 This manual was created with special care on the technical content and the correct verbalisation.
PAGE 2
... the right weigh 1. SAFETY INFORMATION .................................................................. 2 2. CHARACTERISTICS......................................................................... 3 DISPLAY.............................................................................................................. 3 MECHANICAL....................................................................................................... 3 SAFETY & ENVIRONMENT .................................................
PAGE 3
... the right weigh 2. Characteristics DISPLAY Character Height Number of digits Resolution Technology Designator Backlight 45 mm 6 Seven segments plus colon and decimal point Transflective positive TN LCD Permanent label sticker (eg. kg, t, rpm,°C, pH) Yes; amber LEDs MECHANICAL Size casing Size inc.
PAGE 4
...
PAGE 5
... the right weigh 3. Operation Notes INSTALLATION NOTES To comply with various safety and conformance rulings, the system must be properly grounded. The Scoreboard itself needs to be connected to safety earth, and the connector should be firmly mated and fixed by use of fixing screws. When power is applied, the display should respond by a sequence of control messages: Project number, version number, baud rate and address. After the short start-up formality, display is blanked.
PAGE 6
... the right weigh PROGRAMMING OPERATIONAL PARAMETERS The PROG Signal (pin 4) will force the display into Programming Mode when high. The display will show "Programming" and only simple configure commands will be accepted at 9600,8,N,1. Before and after programming sequence, communication is set to the selected speed Note that the PROG pin should remain low or unconnected (inactive) during normal operation. Do not allow unconnected leads to the Prog Pin during normal operations.
PAGE 7
... the right weigh EC – Declaration of Conformity Flintec GmbH Bemannsbruch 9 D-74909 Meckesheim The following named product: FRD-45 BL Display is conform to the following european directives and standards: EN55011, EN50082 (Part 1 and 2) and CENELEC EN 60742 Meckesheim, 1.3.2001 Gerhard K.
PAGE 8
... the right weigh 4. SERVICE AND CONTACT INFORMATION Flintec GmbH Bemannsbruch 9 74909 Meckesheim Germany Tel.:+49 6226 9240 0 Fax :+49 6226 9240 99 http://www.flintec.