User Manual

ManualsBrandsFlintec ManualsHardwareFRD – 67

FRD-67 page 1 of 4 11.02.2011/GG

Display

6 numeric digits of 67 mm height

High impact red LEDs with a 30° intensity cone

Automatic intensity adjustment

Interface

Field selectable RS-232 and RS485/422

Setup of communication parameters and protocol by use of a terminal/PC

Connection

Two cable glands and internal terminals

Cable diameter 6mm to 12mm

Power

100-240VAC/max 25W or 12VDC selectable

Enclosure

Lacquered steel IP65 cabinet for outdoor

FRD

–

67 user’s guide

Summary of content (4 pages)

PAGE 1
FRD – 67 user’s guide Display 6 numeric digits of 67 mm height High impact red LEDs with a 30° intensity cone Automatic intensity adjustment Interface Field selectable RS-232 and RS485/422 Setup of communication parameters and protocol by use of a terminal/PC Connection Two cable glands and internal terminals Cable diameter 6mm to 12mm Power 100-240VAC/max 25W or 12VDC selectable Enclosure Lacquered steel IP65 cabinet for outdoor ©2011 Flintec GmbH reserves the right to change the specifications
PAGE 2
IMPORTANT INSTALLATION NOTES The enclosure must be connected to Protective Earth. This is vital for safe operation. Failure to observe correct grounding may cause serious injury or death. Grounding is further vital for full CE-compliance and must be provided for correct operation. Disconnect power when servicing the display DIMENSIONS in metric millimeters MECHANICAL MOUNTING Open the front lid using a Torx TX-20 screwdriver. Internal screws are Torx TX-15 and Philips/flat for power supply terminals.
PAGE 3
NORMAL POWER-UP When power is applied, the display should respond by a sequence of control messages like software number, baud rate and address. After the short start-up formality, display is blanked, filled with decimal points or zeroed. For automatic settings and other controller card specific features, the behaviour may differ. Consult the actual User's Guide for the installed card.
PAGE 4
IMPORTANT MAINTENANCE NOTES Disconnect power when servicing or maintaining the display ! MAINTENANCE Normal maintenance includes washing off dust with a well wetted cloth. Use plenty of water with a mild detergent to avoid scratching the surface. REPAIR All parts of the display are field repairable. You are however adviced to contact factory for specific instructions for repair. Make sure you maintain all approvals when replacing failing parts. Factory repair ensures a period of 12 months limited warranty.