Owner manual

FT-13 Technical Manual, Rev. 1.40 March 2013
Page 26 of 56
Process Messages
Description
It is displayed during automatic zeroing.
It is displayed during “Gate position control”.
It is displayed at the end of the filling. It is shown alternately
to the weight value. It disappears when emtying starts.
Discharge delay message.
For emptying the tank/hopper manually, activate the
emptying input. This message is shown on the display when
the input is active.
7.3.8 Programme 7: Filling the bag
Standing
Hanging
Operation:
This filling mode controls filling machines which are filling the bag by weighing the bag holding and/or catching
the system as shown in the figures above.
The process cycle starts with the start input in the ready status. The “close the clamp” output will be set
and then the filling is start if the “clamp is closed” input is active.
At the end of the filling FT-13 waits for the “d_End delay” time to release the clamp.
The process cycle ends when the load is removed from the scale.
The vibration output is used to concentrate the material in the bag.
Process Parameters
Description
+ + +
When type FT-13 is in the “Ready” status (the top LED in
the LED bar is “on” ) press the keys shown on the left
sequentially.
“d_hoLd” is the clamp close delay time. The “Close the
clamp” output will be activated after this time period. The
delay time can be entered by the keypad from 0 to 25,0
seconds.
XX.X
d_hoLd
- ZEro -
FULL
XXXXX
GAtE
d dEL
dSChrG