Junction Box Type KA-1 TECHNICAL MANUAL Flintec GmbH Bemannsbruch 9 74909 Meckesheim GERMANY www.flintec.
RIGHTS AND LIABILITIES All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, mechanical, photocopying, recording, or otherwise, without the prior written permission of Flintec GmbH No patent liability is assumed with respect to the use of the information contained herein. While every precaution has been taken in the preparation of this book, FLINTEC assumes no responsibility for errors or omissions.
INTRODUCTION AND TECHNICAL DATA The Aluminium junction box is designed for the connection of 1 load cells. Type KA-1 No. of load cells 1 Housing size 64 x 98 x 34 mm Input 1x M16 Output 1x M16 The junction box type KA-1 can be connected to the instrumentation with a shielded 6-wire signal cable.
After all conductors have been connected, the cable glands must be tightened. Please verify that all cable glands are tight and the cable is fully stress relieved. OUTPUT CABLE CONNECTION The signal cable (connection between junction box and the following electronics) should be a 6 – wire shielded cable and has to be kept as short as possible. Depending on type and manufacturer signal cables may have different colours. Therefore make your own choice.